Zebra WhereTag Accesorios
Listado de partes que complementan sus productos
- Opciones
The Reference Tag mounting kit replaces the Reference Tag kit that formerly incluido the Tags. This kit requires 2 standard tags as reference tags ordered separately. This kit also requires 2 WhereTag IV Snap-On Mounting Rings ordered separately. It cont. En Stock: Envio Mismo Dia* |
||
Replace your standard Torx cover screws con pinned Pentalobe security screws. Kit contains 400 pinned Pentalobe screws plus 2 matching pinned Pentalobe driver bits. para up to 100 tags.. En Stock: Envio Mismo Dia* |
||
Poly-Lock Mounting Strip, 1.00 x 2.50 x 250 SPSI, Box of 40. En Stock: Envio Mismo Dia* |
||
For fixed-mounting of tags on hot surfaces. Kit contains 10 air-gap mounting plates, which have extended height feet to provide a 1/8" air-gap between the tag y the mounting surface, as well as applicable hardware para attaching tags to the mounts.This m. En Stock: Envio Mismo Dia* |
||
"For fixed-mounting of tags. This kit contains 10 mounting plates, y applicable hardware para attaching the tag to the mount. Mounts may be attached to tracked assets con installer-supplied hardware. Plates are designed to fit M3, M6, 4-40, or 1/4" hard". En Stock: Envio Mismo Dia* |
||
The WhereTag IV Snap-on Mounting Ring fits onto the WhereTag IV asset tag to provide mounting tabs con screw y rivets holes to match the WhereTag III mounting design. This mounting ring should be used in cases where the customer has standardized on usi. En Stock: Envio Mismo Dia* |
||
This Extension Adapter mounts on a TM-225-03. It contains an 1.25" extension piece that is approximately 5.5 inches wide, metal bracket y screws. This adapter when connected con a TM-225-03, mounts RTLS Tags onto Trailers.. En Stock: Envio Mismo Dia* |
||
This Extension Adapter mounts onto a TM-225-03. This adapter kits contains a Slide-In 3 pulgadas long extension that is 1.5 inches wide, metal bracket y screws. This adapter when connected con a TM-225-03, mounts RTLS Tags onto Rail Cars y ISO Containe. En Stock: Envio Mismo Dia* |
||
WhereTag Rugged Shock Protector, Same as TM-227-03 except color is Green. En Stock: Envio Mismo Dia* |
||
WhereTag Rugged Shock Protector, Same as TM-227-02 except color is Watermelon. En Stock: Envio Mismo Dia* |
||
Protective Case para WhereTag III, WhereTag III HO y WhereTag IV devices. Attaches to Asset or trailer mount con two screws or rivets. Foam pads on all six sides absorb extreme shocks.. En Stock: Envio Mismo Dia* |
||
This Adapter snaps onto a TM-225-03 y then it can be dropped into the top of ISO containers. It incluye a lead weight y should be considered para use by customers who park ISO containers end-to-end. This cannot be shipped into EU y China.. En Stock: Envio Mismo Dia* |
||
This Temporary Top Slide-In Rail Car / ISO Container Mount is a clip-on mount that slides onto one of the top corners of Rail Car y ISO Containers. The TM-228-00 extension adapter converts the Temporary Top Clip-on Basic Mount to have a 3 pulgadas long ext. En Stock: Envio Mismo Dia* |
||
This Temporary Top Extended Clip-on Trailer Mount was designed para mounting Tags onto top edge (lip) of Trailers. The TM-228-01 extension adapter converts the Temporary Top Clip-on Basic Mount to have a 1.25 pulgadas long extension that is approximately 5.5. En Stock: Envio Mismo Dia* |
||
This Clamp Mount was designed para mounting RTLS Tags onto the top edge (lip) of Trailer, Rail Cars y ISO Containers. This is the preferred solution para customers that need a "low overhang" designed mount. For all other installation, customers should pu. En Stock: Envio Mismo Dia* |
||
An auxiliary mounting device used to mount WhereTag when the tag will be attached to a flat metal surface that is exposed to the sun. The TM-220-01 provides air space between the tag y the surface y prevents the high temperatures the metal experiences. En Stock: Envio Mismo Dia* |
||
Small metal hook attaches to back of WhereCall III+ y V to permit hanging. incluye mounting screws. Sold in lots of 20 only.. En Stock: Envio Mismo Dia* |
||
"Polycarbonate hanger para tag placement on vehicle rear-view mirror. This mount will work con WhereTag III y WhereTag IV tags. WhereTag asset tags are sold separately. Color: Bright Yellow. Minimum 10 pieces per order.". En Stock: Envio Mismo Dia* |
||
For use in moderate conditions where user removal is required. para good adhesion, surfaces must be clean y above 55 degreeF. Will hold well in cold temperatures when applied correctly. Minimum 50 pieces per order.. En Stock: Envio Mismo Dia* |
||
For use in moderate conditions where inexpensive attachment is necessary. para good adhesion, surfaces must be clean y above 55 degreeF. Will hold well in cold temperatures when applied correctly. Foam Mounting Tape is cut into a piece that is 2 pulgadas x 1.3 in.. En Stock: Envio Mismo Dia* |
||
Required tool to install y remove Temporary Trailer, Rail Car y ISO Container Mounts (TM-225-02, TM-225-03, TM-225-04 y TM-225-06). The Pole tip has a flat metal insertion piece.. En Stock: Envio Mismo Dia* |
||
This kit provides 20 Reemplazo covers (tag holder "back door" part #23333rA), para the Temporary Mounts (TM-225-03, TM-225-04 y TM-225-06) to be replaced at customer sites.. En Stock: Envio Mismo Dia* |
||
"Polycarbonate hanger para tag placement on vehicle rear-view mirror. This mount will work con WhereTag III y WhereTag IV tags. WhereTag asset tags are sold separately. Color: British Racing Green. Minimum 10 pieces per order.". En Stock: Envio Mismo Dia* |
||
Clamp, Mounting, Kit, 0.65-1.25 inch, SS (Kit of 10). En Stock: Envio Mismo Dia* |
||
WhereTag Temporary Truck Window Mount to be used in Drayage application. Allows WhereTag devices to be hung from the window of a Drayage truck while on-site at a Marine Terminal. There are 10 mounts incluido in this part number.. En Stock: Envio Mismo Dia* |
||
Metal plate to allow WhereCall II to be mounted in place of WhereCall using WhereCall mounting holes. Also allows use of tie wraps. incluye two machine screws.. En Stock: Envio Mismo Dia* |
||
The WhereTag Drayage Truck Mirror Mount Plate enables a WhereTag III, WhereTag III HO or a WhereTag IV asset tag to be mounted onto a Drayage Truck Mirror. It is no the complete mounting kit, no clamps are incluido. para orders that contain WhereTag IV a. En Stock: Envio Mismo Dia* |
||
The MaxBlox CD-MX915 hood accommodates wire diameters from .125 to .500 y has a strain relief - Can be used con PAC-HW-01 to connect infoman to WhereTag III ST HO. En Stock: Envio Mismo Dia* |
||
Clamp, Mounting, Kit, 0.65-3.50 inch, SS (Kit of 10). En Stock: Envio Mismo Dia* |
||
The MaxBlox CD-MX9F (female) by BTTechnologies is a professional cable y panel mount 9 pin D -Sub connector - Can be used con PAC-HW-01 to connect infoman to WhereTag III ST HO. En Stock: Envio Mismo Dia* |
||
Turck Cable para WhereCall II PLC - 2 meter length. En Stock: Envio Mismo Dia* |
||
This cable is a WhereTag Serial Telemetry Cable Assy that has a Hirose connector to No Connector con 12 wires. This cable is .61 meters (2 ft) long.. En Stock: Envio Mismo Dia* |
||
WhereTag IV-GT I/O - Reemplazo Battery Pack Kit para 10 Tags. En Stock: Envio Mismo Dia* |
||
WhereTag IV-Bluetooth - Reemplazo Battery Pack Kit para 10 Tags. En Stock: Envio Mismo Dia* |
||
WhereDome III Stabilizing Kit to re-enforce the plastic vertical mounting part.. En Stock: Envio Mismo Dia* |
||
46 foot, Gris, 6 conductor, 24 AWG, Right-Angle Amphenol connector on one end, flying leads on the other.. En Stock: Envio Mismo Dia* |
||
5 ft. whip antenna para use in marine terminal applications in conjunction con WhereTag III ST units that support external antenna. incluye hardware para mounting on top of vehicles.. En Stock: Envio Mismo Dia* |
||
This cable is a WhereTag Serial Telemetry Cable Assy that has a Hirose connector to No Connector con 12 wires. This cable is 10 meters (33 ft) long.. En Stock: Envio Mismo Dia* |
||
A large "C" clamp-style tag mount para use on Trailers, Rail Cars or ISO Containers. This mount attaches to the sides of conveyances conout using a tag installation pole.. En Stock: Envio Mismo Dia* |
||
WhereTag IV-GT Basic- Reemplazo Battery Pack Kit para 10 Tags. En Stock: Envio Mismo Dia* |
||
Omron Photo-eye para use con WhereCall II PLC para automated parts replenishment. En Stock: Envio Mismo Dia* |
||
For use in marine terminal applications. Mount para 24.5 ft. antenna mast para WhereDome con 4 WhereTag III ST HOs y also WhereDome IV.. En Stock: Envio Mismo Dia* |
||
For use in marine terminal applications. 24.5 ft. antenna mast para WhereDome con 4 WhereTag III ST HOs y also WhereDome IV.. En Stock: Envio Mismo Dia* |